Notices
ScoobyNet General General Subaru Discussion

help please wrx smoking

Thread Tools
 
Search this Thread
 
Old Nov 7, 2009 | 03:51 PM
  #1  
steveo135's Avatar
steveo135
Thread Starter
Scooby Newbie
 
Joined: Nov 2009
Posts: 17
Likes: 0
Default help please wrx smoking

Hi guys im new here, and needing advice please, got a classic wrx yesterday on the way home the car lost power and started smoking, ive got home and removed the maf sensor and airfilter, the car has a front mount intercooler on it, and the pipe work has oil inside them, oil appears to be coming out of dump valve. the car starts fine and idles great got loads of compression. on reving the car the wastegate is chattering but noting from the dump valve any help would be great.

Thanks very much Steve
Reply
Old Nov 7, 2009 | 03:52 PM
  #2  
steveo135's Avatar
steveo135
Thread Starter
Scooby Newbie
 
Joined: Nov 2009
Posts: 17
Likes: 0
Default

Sorry if ive posted in the wrong section
Reply
Old Nov 7, 2009 | 04:45 PM
  #3  
mike h's Avatar
mike h
Scooby Regular
iTrader: (10)
 
Joined: Dec 2006
Posts: 1,329
Likes: 0
From: The valleys butt :)
Default

Have you checked all the hose clips are tight on the FMIC pipe work?
Sounds like a hose has come off or loosened.
The oil is from the engine breather system which returns to the intake pipe before the turbo. That's why people install oil catch tanks, to keep oil out of the air intake.

Last edited by mike h; Nov 7, 2009 at 04:50 PM.
Reply
Old Nov 7, 2009 | 04:50 PM
  #4  
dunx's Avatar
dunx
Scooby Senior
iTrader: (3)
 
Joined: Jun 2006
Posts: 14,333
Likes: 0
From: Slowly rebuilding the kit of bits into a car...
Default

The oil is from the breathers, sounds like it's now needing attention, or if you are lucky there may be too much oil in it....

dunx
Reply
Old Nov 7, 2009 | 04:51 PM
  #5  
steveo135's Avatar
steveo135
Thread Starter
Scooby Newbie
 
Joined: Nov 2009
Posts: 17
Likes: 0
Default wrx

yeah ive checked the pipes, they seem tight. the car is idling properly and running ok just smokes with no boost and oil in the pipe work.

thanks
Reply
Old Nov 7, 2009 | 05:51 PM
  #6  
steveo135's Avatar
steveo135
Thread Starter
Scooby Newbie
 
Joined: Nov 2009
Posts: 17
Likes: 0
Default wrx

sorry what i mean by the pipe work was the intercooler pipe work.

thanks again. Steve
Reply
Old Nov 7, 2009 | 06:54 PM
  #7  
mike h's Avatar
mike h
Scooby Regular
iTrader: (10)
 
Joined: Dec 2006
Posts: 1,329
Likes: 0
From: The valleys butt :)
Default

Intercooler pipework will have oil in it due to the engine breathers. Breathers go from the engine back to the inlet pipe before the turbo.
The turbo will pull the oily mist from the breathers through into the FMIC pipework. It leaves an oily film on the inside of the pipes and when it's been sitting idle small pools may appear at the lowest points of the pipework.
Nothing to worry about really, as long as there's not gallons of the stuff in there.
Reply
Old Nov 7, 2009 | 07:17 PM
  #8  
steveo135's Avatar
steveo135
Thread Starter
Scooby Newbie
 
Joined: Nov 2009
Posts: 17
Likes: 0
Default wrx

thier was rather a lot of oil there. just strange it drives good just not boosting. as if the turbo has been removed, but it must be doing something as the waste gate chatters like mad, but nothing from the dump valve

With the smoking, on start up gives a little out the exhaust, and when putting it underload, when it should be on boost.

Thanks for your help.
Reply
Old Nov 7, 2009 | 10:01 PM
  #9  
Glowplug's Avatar
Glowplug
Scooby Regular
iTrader: (8)
 
Joined: Jan 2008
Posts: 5,027
Likes: 1
From: On The Road!
Default

What colour is the smoke??
Reply
Old Nov 8, 2009 | 12:03 PM
  #10  
steveo135's Avatar
steveo135
Thread Starter
Scooby Newbie
 
Joined: Nov 2009
Posts: 17
Likes: 0
Default wrx

hi guys i went out to the car today removed the intercooler pipes to the side if turbo there was a lot of oil in their that was leaking out samco hose the connects the pipes, then ive removed the pipe going to the inlet(butterfly) to find milky oil in the pipe boost, (passenger side), like i said the car has a front mount so it has monsterpipe work. ive got fingers in turbo and can move the impeller up down left right.
also the dosent boost as such it trys then drives like crap.

please note no oil in water and vice verser.

any more advise would be great
Reply
Old Nov 8, 2009 | 12:52 PM
  #11  
cdm1's Avatar
cdm1
Scooby Regular
iTrader: (5)
 
Joined: Feb 2005
Posts: 398
Likes: 0
Default

If you can move the impeller with your finger sounds like you turbo has gone mate . You shouldn't be able to move the impeller at all apart from spinning it round.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
shorty87
Full Cars Breaking For Spares
19
Dec 22, 2015 11:59 AM
Sub-Subaru
General Technical
1
Sep 28, 2015 12:47 PM
bugeyedom
General Technical
7
Sep 27, 2015 07:24 PM
alex_00s
Drivetrain
2
Sep 26, 2015 06:07 PM
slimwiltaz
General Technical
4
Sep 25, 2015 10:22 PM




All times are GMT +1. The time now is 07:52 PM.