firing on 3
if u are putting out low boost chances are ur in limp mode but yes if u were running on 3 u would get relly slow to build boost and revs , connect the two black connectors underneth the steering wheel and turn the ignition to on but dont start , the read the check engine light , a long flash means 10 a short flash means 1 for example
+ = long flash
- = short flash
+++--- would mean 33
u may only only get one code but if u get more than one then it will repeat istelf over
for example :
+++--- then +- then ++++- then +++--- then +- then ++++-
33 , 11 , 41 , 33 , 11 , 41 see it reats itself over and over this is an example of 3 codes displayed 33 , 11 , 41 then repeat u may only get one .
if u dont get any then ur are probably getting engine knock , plz dont anyone say that u would get a code for the knock sensor because i am one of three people i have known who all had this problem with no check engine light showing all it showed was a continous flash whch means no code or ok , sorry m8 if u already know how to read the codes no offence but there are people who dont ? if u are running on 3 then a closed spark plug gap , faulty coil pak / broken wire to coil pack / coil pack plugged into wrong cylinder and sometimes a crank or cam sensor can be at fault but would mostly give a non start so i doubt its these two ? also try a compression test just to be sure
+ = long flash
- = short flash
+++--- would mean 33
u may only only get one code but if u get more than one then it will repeat istelf over
for example :
+++--- then +- then ++++- then +++--- then +- then ++++-
33 , 11 , 41 , 33 , 11 , 41 see it reats itself over and over this is an example of 3 codes displayed 33 , 11 , 41 then repeat u may only get one .
if u dont get any then ur are probably getting engine knock , plz dont anyone say that u would get a code for the knock sensor because i am one of three people i have known who all had this problem with no check engine light showing all it showed was a continous flash whch means no code or ok , sorry m8 if u already know how to read the codes no offence but there are people who dont ? if u are running on 3 then a closed spark plug gap , faulty coil pak / broken wire to coil pack / coil pack plugged into wrong cylinder and sometimes a crank or cam sensor can be at fault but would mostly give a non start so i doubt its these two ? also try a compression test just to be sure
i also had a bad timing belt tensioner that made the timing belt jump a tooth on one of the cam pulleys , gives a running on 3 symptom slightly but most times it would not start these are bad for going on some models but not often
thanks for the reply, i was just wondering if my other problem on my other post could be causing me to run on 3 cylinderd but i dont think it would, i did try all the coils with a plug in to see if they have a spark and they do, so i cant be on 3 cylinders, the fault check will come in handy though, thanks very much, all the best, phil.
Thread
Thread Starter
Forum
Replies
Last Post
DogsofWar
Engine Management and ECU Remapping
16
Sep 23, 2015 07:41 PM



but i doubt that , these things are like having a second wife
