White Classic Track Car Project
#181
Scooby Regular
Thread Starter
iTrader: (5)
Join Date: Sep 2006
Posts: 261
Likes: 0
Received 0 Likes
on
0 Posts
Front cage section fitted at last.
Cage mounted mirror fitted.
Went a bit BluePeter with some left over lexan and made the centre dash piece and a ECU bracket.
Bits fitted.
Battery wiring and fire extinguisher next.
Cage mounted mirror fitted.
Went a bit BluePeter with some left over lexan and made the centre dash piece and a ECU bracket.
Bits fitted.
Battery wiring and fire extinguisher next.
#184
Scooby Regular
iTrader: (20)
I was thinking for the same thing.I found this but don't know if anyone has fitted one of these on there impreza.
http://www.ebay.co.uk/itm/2209551617...84.m1423.l2649
http://www.ebay.co.uk/itm/2209551617...84.m1423.l2649
#187
Scooby Regular
Thread Starter
iTrader: (5)
Join Date: Sep 2006
Posts: 261
Likes: 0
Received 0 Likes
on
0 Posts
Thanks mate. After moving the battery to inside the engines playing up. On idle revs rise to 1800 every few seconds and its running super rich, black smoke? The Apexi is showing 5% injector then dropping to 0% and back up to 5%. Any ideas? Ive run the new + cable to starter motor and from there to the fusebox 12v connection feed. Ive earthed the battery - to the body and a seperate earth from engine to chassis. Thanks
#190
Scooby Regular
Thread Starter
iTrader: (5)
Join Date: Sep 2006
Posts: 261
Likes: 0
Received 0 Likes
on
0 Posts
Hi guys, major change of plans. Decided to buy a 05-07 Sti now so I will be stripping the car. Various reasons, need a day to day car and the whole trackday thing would be quite alot of grief and expensive. Gutted, but at the same time just having a road car and going back to shows/meets made my mind up. Check sales section for parts, cheers guys.
#198
Scooby Regular
Thread Starter
iTrader: (5)
Join Date: Sep 2006
Posts: 261
Likes: 0
Received 0 Likes
on
0 Posts
Bit sad but i covered the original vents with cardboard and taped up tight. Then put plastic sheet on top and stuck in the oven so it formed the shape. Best to do slowly on low heat then smooth over with a skim of filler.
Thread
Thread Starter
Forum
Replies
Last Post
ossett2k2
Engine Management and ECU Remapping
15
23 September 2015 09:11 AM