wagon fettle
#661
Hi Ian,
I think yours is the Bosch 044, 200lph 5 bar pump.
The Bosch Motorsport is the 200 lph 10 bar pump Roger Clark Motorsport - RCM Product Detail
Piccy of the part number...
Trust this helps...
The build is looking good fella....
I think yours is the Bosch 044, 200lph 5 bar pump.
The Bosch Motorsport is the 200 lph 10 bar pump Roger Clark Motorsport - RCM Product Detail
Piccy of the part number...
Trust this helps...
The build is looking good fella....
#665
Ha ha. ian, i am picking my 6 speed up next week oh and got some d2 8 pots as well. Works out im paying 200 quid for my 8 pots with disks and pads!
Still hav'nt got my fuel pump though
Still hav'nt got my fuel pump though
#676
Scooby Regular
Thread Starter
iTrader: (41)
Join Date: Nov 2003
Location: in the woods...........555 Wagon Sqn
Posts: 13,347
Received 55 Likes
on
42 Posts
I've got a couple of days off next week where I hope all the little things will add up to some good progress...so only a little bit of this today,
but mostly this...
but mostly this...
#687
Scooby Regular
Thread Starter
iTrader: (41)
Join Date: Nov 2003
Location: in the woods...........555 Wagon Sqn
Posts: 13,347
Received 55 Likes
on
42 Posts
Got some bits and pieces done today; cut the OE slam panel support out and made up an A-frame to replce it...that's gone to be welded
Carried on with the indicator\ram air re-site; trimmed up off all the indicator moutning points frm the bumper...lots more trimming than anticipated but I'm pleased with the results. Cut, shaped and painted the mesh so its ready to be lacquered tomorrow and fitted Thursday.
made a scary cut to the bumper; the slot for the vent for my oil-cooler outlet...can't even offer the vent up yet as I painted that today too...fingers crossed I've not made a bl00dy great mess
I finally finished cutting the 10mm steel disks so Zak can weld up my sub frame which, should be welded up tomorrow...feel like I'm making progress for a change
Carried on with the indicator\ram air re-site; trimmed up off all the indicator moutning points frm the bumper...lots more trimming than anticipated but I'm pleased with the results. Cut, shaped and painted the mesh so its ready to be lacquered tomorrow and fitted Thursday.
made a scary cut to the bumper; the slot for the vent for my oil-cooler outlet...can't even offer the vent up yet as I painted that today too...fingers crossed I've not made a bl00dy great mess
I finally finished cutting the 10mm steel disks so Zak can weld up my sub frame which, should be welded up tomorrow...feel like I'm making progress for a change