Hi Ian,

I think yours is the Bosch 044, 200lph 5 bar pump.

The Bosch Motorsport is the 200 lph 10 bar pump Roger Clark Motorsport - RCM Product Detail

Piccy of the part number...



Trust this helps...

The build is looking good fella....

 

thanks for the info and the kind words Ross

 

i think these are cool...i think i'm a geek.

 

Correct on both counts Ian

 

Ha ha. ian, i am picking my 6 speed up next week oh and got some d2 8 pots as well. Works out im paying 200 quid for my 8 pots with disks and pads!
Still hav'nt got my fuel pump though

 

Have used various LED sidelights bulbs over the years (cheap & expensive) and none of them seem to last , gone back to using normal bulbs now

ps...you a geek, hmmm never

 

who said they were side lights Ian

geek chic

 

Ok what are they then

 

Rear number plate illuminators ?

 

Ian you will have to guess

Stu; nope

 

Don't know and don't care

Didn't see you yesterday, we were there so long i started growing a beard

 

Fine, won't tell you then

Yeah, bloody busy yesterday, mean I actually had to work the whole day so no time for anything else. what a liberty

 

Not quite as I'd planned by all good

Tracktive Solutions - Hydra Nemesis EMS

 

.....index finger illuminators?

 

^^^ wouldn't have helped...the nail would still have pierced my finger nail!!

 

I've got a couple of days off next week where I hope all the little things will add up to some good progress...so only a little bit of this today,


but mostly this...

 

bloody pikeys

 

iv got your harness bar in my garage Ian, just waiting for the rose joints

il drop you a pm towards the end of the week.

cheers
jon

 

tell me about it, that bloke has been hanging about for a bit...I've got my eye on him

 

thanks Jon

 

hmmm whats under the cover!!

 

Is it a type R shell?

 

Ssssssshhhhh

 

Nope, just a four door

 

That the shell that Mark had?

 

Don't think so Steven, it was sourced locally.

 

Got some bits and pieces done today; cut the OE slam panel support out and made up an A-frame to replce it...that's gone to be welded


Carried on with the indicator\ram air re-site; trimmed up off all the indicator moutning points frm the bumper...lots more trimming than anticipated but I'm pleased with the results. Cut, shaped and painted the mesh so its ready to be lacquered tomorrow and fitted Thursday.



made a scary cut to the bumper; the slot for the vent for my oil-cooler outlet...can't even offer the vent up yet as I painted that today too...fingers crossed I've not made a bl00dy great mess


I finally finished cutting the 10mm steel disks so Zak can weld up my sub frame which, should be welded up tomorrow...feel like I'm making progress for a change

 

About time good to see it coming along though

 

lol you and me both Ian

 

someone has been busy buddy