Oh well, it was bound to happen, the engine has now blown up
15 October 2007, 01:16 PM
#61
Scooby Regular
iTrader: (1)
Join Date: Mar 2005
Location: In RS land......
Posts: 12,902
Likes: 0
Received 0 Likes
on
0 Posts
If its along the same lines as the old engine all the plugs etc should fall into the correct position approx with the loom in the correct place, if not HA HA have fun..
only just seen that....
10 November 2007, 12:42 PM
#67
Scooby Regular
Thread Starter
iTrader: (6)
Join Date: Apr 2005
Location: Stroke it baby!
Posts: 33,828
Likes: 0
Received 0 Likes
on
0 Posts
Getting near the end with this little project now.
Car is all back on the
ground ..
Engine and box all in, all hoses attached, and all plugs "plugged" but one
Car is all back on the
ground ..Engine and box all in, all hoses attached, and all plugs "plugged" but one
10 November 2007, 02:24 PM
#71
Scooby Regular
Thread Starter
iTrader: (6)
Join Date: Apr 2005
Location: Stroke it baby!
Posts: 33,828
Likes: 0
Received 0 Likes
on
0 Posts
I managed to snap the ball off the end when dropping the engine in, trying to source one of these has been murder. Over £100 from Pug too
10 November 2007, 02:29 PM
#73
Scooby Regular
Join Date: Apr 2005
Location: I've joined the Focus family
Posts: 7,623
Likes: 0
Received 0 Likes
on
0 Posts
10 November 2007, 02:35 PM
#74
Scooby Regular
Thread Starter
iTrader: (6)
Join Date: Apr 2005
Location: Stroke it baby!
Posts: 33,828
Likes: 0
Received 0 Likes
on
0 Posts
Tried them just now, unfortunatly as i suspected, as was the case with ECP also, its too specialised. It looks like i may have to grind the remainer of the old one off, drill and bolt an aftermarket one on. 
All good fun but its holding me up now
All good fun but its holding me up now
10 November 2007, 02:42 PM
#77
Scooby Regular
Join Date: Apr 2005
Location: I've joined the Focus family
Posts: 7,623
Likes: 0
Received 0 Likes
on
0 Posts
19 November 2007, 02:05 PM
#83
Scooby Regular
Thread Starter
iTrader: (6)
Join Date: Apr 2005
Location: Stroke it baby!
Posts: 33,828
Likes: 0
Received 0 Likes
on
0 Posts
Update..
All tyres pumped up
Entire car is built now, and ball problem solved.
Filled with fluids, put new battery on, turned key and....
click - thats all I got a click. suspected starter motor, or wiring fault. FFS
Gonna have another fiddle with it, then might call the AA out for homestart
All tyres pumped up
Entire car is built now, and ball problem solved.
Filled with fluids, put new battery on, turned key and....
click - thats all I got a click. suspected starter motor, or wiring fault. FFS
Gonna have another fiddle with it, then might call the AA out for homestart
19 November 2007, 02:23 PM
#84
Former Sponsor
iTrader: (4)
Join Date: Jul 2003
Location: @Junc 12, M40 Warwicksh; 01926 614522 CV33 9PL -Use 9GX for Satnav. South Mids Alcatek ECu dealer
Posts: 6,377
Likes: 0
Received 3 Likes
on
3 Posts
The Subaru is ready. I left a message on your cell last Thursday am, but no call. Did you get it ??
David
David
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM