the shreksta

iTrader: (20)

as you know i have had all my brakes replaced (new front rotors/pads,rear discs and pads and the handbrake adjusted) after my car has been stood all day at work i go to drive off and its like something is sticking and it sort of bangs/clunks as i pull away,after that its fine its only when the car has been stood for a long time,the brakes work fine and pull me up straight and true and the handbrake holds good on 4/5 clicks

any ideas?

JDM_Stig

iTrader: (3)

could just be the handbrake sticking a little, the shoes will be new so so all the sharp edges etc intact, give it a few K miles and see if its the same.

the shreksta

iTrader: (20)

it didnt have new shoes mate,the brakes have been on for 2 weeks now and this has only started to happen in the past 2/3 days

DT-SPD

iTrader: (7)

Sounds like pads moving in the caliper. After the initial clonk does it stop until you then reverse ?

ken-sti

If you rule out the brakes themselves, its possible that your hub nuts need tightening up. Had this one mine that i was finding a clunk noise when starting stopping and sometimes dropping down a gear, got a tiny bit on the hub nuts and sorted it out...you'l need a big bar though!