I need to replac the pads on the my impreza 2000
#2
Scooby Regular
Join Date: Oct 2006
Location: deepest darkest dorset ripping up the A30 in a red V5
Posts: 534
Likes: 0
Received 0 Likes
on
0 Posts
hi ive just replaced my old mintex with ebc redstuff
the stopping power is ok but they produce alot more brake dust than the mintex so prob would fit mintex next time
any other views on this???
the stopping power is ok but they produce alot more brake dust than the mintex so prob would fit mintex next time
any other views on this???
#3
I had mintex 1155 pads front and rear on a 99 uk turbo.
Good points; cheap, good stopping versus OEM
Bad points; eat discs, squeal like hell at slow speed
I now have Pagid 4-2-1 on front with tarox on rear. Dearer but much better for stopping and noise. I would be a lot happier if Pagids were also made for the rear but they're not. I felt that the balance of the car was probably better with the same pads all round but I could not stand the noise and to be honest the braking distance is less with the Pagids. IIRC the mintex didn't last too long either circa 25000 and the pagids are still going strong with 35000+ and the discs look OK too.
Pat
Good points; cheap, good stopping versus OEM
Bad points; eat discs, squeal like hell at slow speed
I now have Pagid 4-2-1 on front with tarox on rear. Dearer but much better for stopping and noise. I would be a lot happier if Pagids were also made for the rear but they're not. I felt that the balance of the car was probably better with the same pads all round but I could not stand the noise and to be honest the braking distance is less with the Pagids. IIRC the mintex didn't last too long either circa 25000 and the pagids are still going strong with 35000+ and the discs look OK too.
Pat
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
KOEScoob
ScoobyNet General
6
17 September 2015 03:51 PM