braided hose problems?
#1
Scooby Regular
Thread Starter
iTrader: (29)
Join Date: Aug 2006
Location: aberdeenshire
Posts: 656
Likes: 0
Received 0 Likes
on
0 Posts
braided hose problems?
fitting godspeed red brembo conversion to my classic.
fitted the kit and brakes were extremley hard. one piston was previously stuck but have freed it off. after this went for a spin and split a metal brake line at union. metal lines were all replaced a few months back. took off braided line on side it split at and tried blowing through with compressor. compressor cuts out at preset level.
i take it i should be able to blow through a braided line by mouth pretty easily?, which i cant.
if so would braided lines for gold brembos fit ok? distance between collar going through strut bracket and caliper union is about 26.5cm.
any help greatly appreciated.
fitted the kit and brakes were extremley hard. one piston was previously stuck but have freed it off. after this went for a spin and split a metal brake line at union. metal lines were all replaced a few months back. took off braided line on side it split at and tried blowing through with compressor. compressor cuts out at preset level.
i take it i should be able to blow through a braided line by mouth pretty easily?, which i cant.
if so would braided lines for gold brembos fit ok? distance between collar going through strut bracket and caliper union is about 26.5cm.
any help greatly appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
Pro-Line Motorsport
Car Parts For Sale
2
29 September 2015 07:36 PM