Soggy pedal
#1
Soggy pedal
Fitted my wilwood six pots today and having trouble getting a solid pedal, brakes do work but just a lot of travel.
Pretty confident all the air is bled out the system and fitted new braided lines to the front and dot 5 fluid.
I was wondering if the master cylinder was up to the job as its a bit of a jump from 2 pots to 6 and just wondered if anyone else has had this problem when upgrading brakes ?
Steve
Pretty confident all the air is bled out the system and fitted new braided lines to the front and dot 5 fluid.
I was wondering if the master cylinder was up to the job as its a bit of a jump from 2 pots to 6 and just wondered if anyone else has had this problem when upgrading brakes ?
Steve
#2
Scooby Regular
sounds like they still may have air in the system, did you bleed the rears also?? must do to sort properly, also daft one but you do have the bleed nipples to the top!!
if not they will never bleed up fully
alyn
if not they will never bleed up fully
alyn
#5
Bleed nipples at the top and started at the rear as i drained the old fluid so a total flush through, is there a correct order to bleed the front calipers ? inside outside nipple first ?
#6
Scooby Regular
outside nipple first, then inner.......and start from N/S/F and then diagonally opposite to O/S/R, repeat for other O/S/F and then N/S/R....................
alyn
alyn
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
shorty87
Full Cars Breaking For Spares
19
22 December 2015 11:59 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
matt12
ScoobyNet General
59
08 November 2015 09:15 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
22 October 2015 06:12 AM