Raised edge on rear disks
#1
Raised edge on rear disks
I was getting my exhaust, when someone remarked that the rear brake pads did not cover the whole disk, leading to a raised edge.
Spec:
UK MY00 Turbo rear single pot calipers
Mintex 1144 pads
DBA 650 Vented disks
Any comments, suggestion of a pad that covers the whole disk?
the swordmaster
Spec:
UK MY00 Turbo rear single pot calipers
Mintex 1144 pads
DBA 650 Vented disks
Any comments, suggestion of a pad that covers the whole disk?
the swordmaster
#4
Originally Posted by stevem2k
OMP pattern pads apparently use a slightly larger disc radius that cleans up the edge line...
Steve
Steve
regards
the swordmaster
#5
Scooby Regular
Don't know about the rears, but I just put some front discs on that were covered in surface rust. The existing pads were Ferodos I think, and they left an inner unswept line about half an inch wide. Put a new set of OMP pads, which incidentally are dirt cheap and seem to perform very well, and within a day the discs were totally clean inside to outside. There's someone on ebay (ybracing) who's flogging OMP pads and tbh I can't argue with the prices - £30 for front pads for 4 pots and £20 for rear pads for sliding single pot calipers. Plus they work up to 600 C.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Sub-Subaru
General Technical
1
28 September 2015 12:47 PM