Bedding in EBC Red Ceramic Pads
#1
Scooby Regular
Thread Starter
Join Date: May 2004
Location: North West
Posts: 727
Likes: 0
Received 0 Likes
on
0 Posts
Bedding in EBC Red Ceramic Pads
Is anybody aware of any recommended procedures for these pads? I've seen recommended procedures for bedding other pads but not EBC pads.
If you've been using these pads did you follow any guidelines to bed them in?
If you've been using these pads did you follow any guidelines to bed them in?
#3
Scooby Regular
iTrader: (1)
Join Date: Jan 2004
Location: Lancaster/Manchester or stuck in a traffic jam somewhere in between
Posts: 2,232
Likes: 0
Received 0 Likes
on
0 Posts
I went through this when I fitted them to mine... I had heard all sorts of different methods... drive to 50 mph brake hard but release before hitting 10mph, repeat this 3 times reducing the top speed by 10 mph each time and other (wasn't exactly that but something similar).
In the end,
I just took it easy, no "fast road" driving and no unnecessary emergency stops for about 250 miles. Same as 7 foot really LOL
Oh, when they were bedded in, they're absolutley spot on... never got fade once. The hotter they get the better they get. And they werent anywhere near as bad as people made out about them when they're cold.
J
In the end,
I just took it easy, no "fast road" driving and no unnecessary emergency stops for about 250 miles. Same as 7 foot really LOL
Oh, when they were bedded in, they're absolutley spot on... never got fade once. The hotter they get the better they get. And they werent anywhere near as bad as people made out about them when they're cold.
J
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM