Tightening Handbrake
#1
Scooby Regular
Thread Starter
Join Date: May 2002
Location: Limavady.
Posts: 268
Likes: 0
Received 0 Likes
on
0 Posts
Tightening Handbrake
Can some one please tell me which way to click the wheel on the drum to tighten the handbrake. I tried a good few clicks up and down on saturday but didnt make any difference on the drivers side.
Thanks
Thanks
#2
It's better to adjust it through handbrake directly thus you adjust the same left-right drums, there are two bolts under the plastic trim where the handbrake is - just tighten them a bit, of course this means you have to take off the plastic cover.
JIM
JIM
#3
Scooby Regular
Thread Starter
Join Date: May 2002
Location: Limavady.
Posts: 268
Likes: 0
Received 0 Likes
on
0 Posts
I was going to do that but didnt want to remove all the plastic in the middle.
One side is more biased than the other - so i would need to get them both even before i tighten the cable
thanks for your reply Jim
One side is more biased than the other - so i would need to get them both even before i tighten the cable
thanks for your reply Jim
#5
Scooby Regular
Thread Starter
Join Date: May 2002
Location: Limavady.
Posts: 268
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Ian Godney
send me your email address and I will mail you an instruction sheet
Many thanks
Sloaner
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
55
05 August 2018 07:02 AM
KK3960
General Technical
3
07 October 2015 12:33 PM