Scooby boffin wanted! ABS problem!
Thread Starter
Scooby Newbie
Joined: Nov 2003
Posts: 2
Likes: 0
My ABS doesn't work and the warning light is on.
Diagnostic equipment (Select Monitor) shows low supply voltage to the ABS ECU but the voltage measured at the ECU multiplug is correct at 13.8v.
Does anyone know how or who can fix this?
Please, please help!!!
'Desparate' in Derby! (Also 'Braked-out' in Battersea)
Diagnostic equipment (Select Monitor) shows low supply voltage to the ABS ECU but the voltage measured at the ECU multiplug is correct at 13.8v.
Does anyone know how or who can fix this?
Please, please help!!!
'Desparate' in Derby! (Also 'Braked-out' in Battersea)
Scooby Regular
iTrader: (3)
Joined: Aug 2000
Posts: 25,565
Likes: 2
From: 1600cc's of twin scroll fun :)
Sorry but im not a brake person but i can give you some advice 
You havnt stated which model or year car you have, earlier versions had 2 circuit abs, this then went to 3 circuit abs and now the later models have 4 circuit abs.
The biggest cause of failures is a broken sensor, normally clobbered by a stone after some "energetic driving"
Tony
You havnt stated which model or year car you have, earlier versions had 2 circuit abs, this then went to 3 circuit abs and now the later models have 4 circuit abs.
The biggest cause of failures is a broken sensor, normally clobbered by a stone after some "energetic driving"
Tony
Thread
Thread Starter
Forum
Replies
Last Post
Bazil_SW
Engine Management and ECU Remapping
24
Sep 21, 2015 11:55 PM