Changing from 2 pots to 4 pots help required !!
09 January 2003, 01:26 PM
#1
Scooby Regular
Thread Starter
Join Date: Jul 2003
Location: Sheffield Scoob Central!!
Posts: 733
Likes: 0
Received 0 Likes
on
0 Posts
as above changing from sh1ty 2 pots to some scooby 4 pots off the later model... What do I need to do ? is it a simple straight swap 2 pots off 4 pots on, or are the mounting brakets different & discs ??
Can anyone help me before I run in to the back of a lorry ??
Cheers
[Edited by Scooby_Dan. - 9/1/2003 1:27:03 PM]
Can anyone help me before I run in to the back of a lorry ??
Cheers
[Edited by Scooby_Dan. - 9/1/2003 1:27:03 PM]
01 September 2003, 01:34 PM
#3
Scooby Regular
Join Date: Feb 2001
Location: Kent
Posts: 555
Likes: 0
Received 0 Likes
on
0 Posts
As far as I know they are a direct replacement, they mount on to the same mounting points and the discs should go straight on no problem. If you are replacing the brakes it is worth considering putting braided hoses aswell.
01 September 2003, 02:32 PM
#5
Scooby Regular
Join Date: Aug 2003
Location: Epsom
Posts: 5,832
Likes: 0
Received 0 Likes
on
0 Posts
Yeah you can do this - I was quoted about £350 for some from grade A (http://www.gradea-subaru.co.uk/) - BUT the only prob is , the 4 pots are still not great, I hummed and hawwed about this - in the end spent £1200 getting a 310mm 4 pot setup (largest to go in std 16" wheels). I figured there was no point doing half a job....
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM