Tracking (inner edge wear)
#1
My brother-in-law noticed the N/S front inner edge of my RE011's was bald. I had 4mm across the rest of the tyre. Checked O/S and near same story. After nearly 20K on the original rubber, I was ready to change the tyres anyway (tram lining really badly and road noise- could hardly hear the radio in the car!!!).
So off to Micheldever tyres for a set of SO3's and got the tracking checked at the same time. Guess what- tracking spot on? So why the inner edges knocking out?
Maxus
MY01 WRX (PPP)
So off to Micheldever tyres for a set of SO3's and got the tracking checked at the same time. Guess what- tracking spot on? So why the inner edges knocking out?
Maxus
MY01 WRX (PPP)
#2
Scooby Regular
Think that you will find that it is the geometry that is out , Happened to me as well got TSL to sort it now tottally transforms the car
#5
Had my WRX since end of Oct 02 and noticed yesterday that both front tyres are bald on the inside 1/4. Asked the garage to check the setup just after I bought it as it was tramlining like a bitch and they gave it the all clear. They have agreed to replace both front tyres, maybe they should have set it up properly in the first place!!
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM