Silly engine bits!!
#1
Scooby Regular
Thread Starter
iTrader: (3)
Join Date: Mar 2010
Location: South Lanarkshire
Posts: 191
Likes: 0
Received 0 Likes
on
0 Posts
Silly engine bits!!
I've taken the engine out of my car to sort out a nasty exhaust leak, re shim the valves, change the crankshaft oil pump seal and fit new timing belt. Anyway, while walking from my house to the garage across the DECKING with a tray full of freshly cleaned bits n pieces.......... I tripped and some bits ended up falling down between the slats of the decking. I tried for the best part of an hour and got most of the bits out with a magnet pen but didn't get all of them. So if anyone has the following I would greatly appreciate it!
Heres a pic of the exact bits I need.
I'm looking for
1. A large outter shim 2.30mm thick or bigger
2 5 camshaft cap bolts,
3. 4 rocker cover bolts and rubber gaskets
Surely someone has these lying around in a their garage????
PM me please
Cheers
Trav
Heres a pic of the exact bits I need.
I'm looking for
1. A large outter shim 2.30mm thick or bigger
2 5 camshaft cap bolts,
3. 4 rocker cover bolts and rubber gaskets
Surely someone has these lying around in a their garage????
PM me please
Cheers
Trav
#4
Scooby Regular
Thread Starter
iTrader: (3)
Join Date: Mar 2010
Location: South Lanarkshire
Posts: 191
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the thread replies guys! Sorted now!
Everything was delivered today, thanks to Andy for quick reply and fast postage!
And god bless scoobynet!!
Trav
Everything was delivered today, thanks to Andy for quick reply and fast postage!
And god bless scoobynet!!
Trav
#5
Scooby Regular
Thread Starter
iTrader: (3)
Join Date: Mar 2010
Location: South Lanarkshire
Posts: 191
Likes: 0
Received 0 Likes
on
0 Posts
OK................ got the bolts sorted however the shim i received is to large in diameter, so doesn't fit in the cam follower/bucket. I wasn't clear at the start of the thread tbh so here goes again.
The shim I need is one that is 30mm in diameter and 2.30mm thick or thicker as I can surface grind it to the required size.
Please someone help
Trav
The shim I need is one that is 30mm in diameter and 2.30mm thick or thicker as I can surface grind it to the required size.
Please someone help
Trav
Thread
Thread Starter
Forum
Replies
Last Post
MightyArsenal
Wheels, Tyres & Brakes
6
25 September 2015 08:31 PM
hedgecutter
General Technical
3
25 September 2015 02:35 PM