Aftermarket parts v3 type r
29 April 2005, 10:32 PM
#1
Scooby Regular
Thread Starter
Join Date: Sep 2004
Location: Thanet/Kent
Posts: 247
Likes: 0
Received 0 Likes
on
0 Posts
Aftermarket parts v3 type r
WANTED
F,M,I(blitz,hks)
Equil lenth manifold
Turbo up pipe
540 Injectors
Walbro fuel pump
Aquimist
Boost controller(blitz)
Lightened pulleys
" flywheel
Eibach springs
IHI 28 OR 34 Turbo
Gems or Motec ECU
Also can anyone tell me is it a hard job to turn my inlet manifold round 180 degrees to allow 4 shorter pipewok from the front mount ive been told to expect an increase of about 50lb of torque is this true
F,M,I(blitz,hks)
Equil lenth manifold
Turbo up pipe
540 Injectors
Walbro fuel pump
Aquimist
Boost controller(blitz)
Lightened pulleys
" flywheel
Eibach springs
IHI 28 OR 34 Turbo
Gems or Motec ECU
Also can anyone tell me is it a hard job to turn my inlet manifold round 180 degrees to allow 4 shorter pipewok from the front mount ive been told to expect an increase of about 50lb of torque is this true
30 April 2005, 06:45 PM
#2
you wont get an increase in torque but you will get a lot less lag from the reduced pipework normally associated with a front mount intercooler, to do this you will need to close the original opening and open the other side. not sure how long this would take.
02 May 2005, 04:19 PM
#3
Scooby Regular
Join Date: Mar 2003
Location: North Wales
Posts: 149
Likes: 0
Received 0 Likes
on
0 Posts
Hi,
I have a HKS frount mounted intercooler, 550cc injectors and a lightened flywheel for sale.
Email or PM me - jonesol1@hotmail.com
I have a HKS frount mounted intercooler, 550cc injectors and a lightened flywheel for sale.
Email or PM me - jonesol1@hotmail.com
Thread
Thread Starter
Forum
Replies
Last Post