My "hesitation, stalling & kangarooing" thread in General Technical
#1
Scooby Regular
Thread Starter
iTrader: (4)
Join Date: Aug 2002
Location: Neath, Wales
Posts: 812
Likes: 0
Received 0 Likes
on
0 Posts
My "hesitation, stalling & kangarooing" thread in General Technical
Rather than repeat my war & peace epic/plea for help in the Wales section, here is a link to my post in Gen Tech....
https://www.scoobynet.com/general-te...ngarooing.html
Thanks in advance for any hints and tips etc
https://www.scoobynet.com/general-te...ngarooing.html
Thanks in advance for any hints and tips etc
#2
Scooby Regular
iTrader: (7)
Join Date: Mar 2009
Location: Down West.
Posts: 3,843
Likes: 0
Received 0 Likes
on
0 Posts
Rather than repeat my war & peace epic/plea for help in the Wales section, here is a link to my post in Gen Tech....
https://www.scoobynet.com/general-te...ngarooing.html
Thanks in advance for any hints and tips etc
https://www.scoobynet.com/general-te...ngarooing.html
Thanks in advance for any hints and tips etc
Very good fault information on that thread Dean - would have taken me a week to write that,
Last year when my MAF was dying I had the same issues, juddering on the motorway when cruising and giving slight throttle, like a fuel issue or even sometimes like I was running out of fuel.
I would get an intermittent check light too, which would go after I'd parked it up - switched on and off etc........and it was crap pulling off, the MAF change seemed to sort that I have to say, but left me with a few boost cut issues under load and at accelerating/rising boost press.
This has now gone with the remap - maybe your new set up needs a tweek with your ECU as you now have a bigger air filter cone and TMIC - I read that one of the RCM induction kits with the bigger cone than I have needs a remap to work properly, hope this gives an idea mate, but I know the more technically aware may help much more
Hope you get it sorted Dean
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM