hello,

I've done this alignment in december, but today I was checking the settings and they were the same. when I installed the suspension I didn't have camber bolts so they have this values... is it ok or should I buy camber bolts and adjust them again? the top value in the box is left and the bottom is right.

 

front
caster left 3º42
caster right 3º48
camber left -1º12
camber right -1º24
toe total -0º03

rear
camber left -2º06
camber right -2º00
toe total 0º03

except for the camber they are all inside the factory values, is this ok?

 

It is strange to have so much neg camber in the rear and so little in the front, usually the other way round!

IMO:
You need 2 deg neg in the front too.
You also need a lot more caster, but will need ajustable top plares for that ie Noltec ones.
Graham

 

by this table, the front camber min and max is -0º55 and 0º05 and the rear camber min and max is -1º40 and -0º40. if I adjust the settings to the max the rear will always have more camber...

 

If my memory is correct:

Front:

toe = Zero
Neg camber = 2.5 deg
Caster is posative 7 deg (might be a little less)
Bump steer = Zero (without adjustment)

Rear:

Toe = Zero
Camber = 2 deg neg

All set to +/- 5 minutes.

Graham

 

thanks graham, I think I have picture.