Strut brace keeps hitting intercooler!
#1
Strut brace keeps hitting intercooler!
Fitted my Whiteline strut brace today to my 04 WRX, but the problem is that it keeps banging against my STi intercooler that I have fitted to the car, Is there anything I can do to make it stop hitting it, The strut brace was bought second hand which was took off a WRX with the standard intercooler.
#2
Scooby Regular
iTrader: (8)
Join Date: Nov 2004
Location: Surrey
Posts: 1,405
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by scoobyboy1
Fitted my Whiteline strut brace today to my 04 WRX, but the problem is that it keeps banging against my STi intercooler that I have fitted to the car, Is there anything I can do to make it stop hitting it, The strut brace was bought second hand which was took off a WRX with the standard intercooler.
http://www.powerstation.org.uk
Regards
Anders
#3
Loosen the bolts that hold the intercooler in place and the 2 sir clips that hold the intercooler to the intlet manifold. Pull the intercooler forward as far as possable and tighten them back up. This was what i did when it happen to me. Hope this helps
#5
Scooby Regular
Join Date: Jul 2002
Location: Under your bonnet
Posts: 9,173
Likes: 0
Received 0 Likes
on
0 Posts
I recently did a intercooler swap on a classic shape Impreza (sti-9 intercooler) and this made the standard STi strut brace do exactly that..
The cure was to fit a whiteline one.
You could try bending the brackets that hold the intercooler, so that it sits a little lower in the engine bay??
Andy
The cure was to fit a whiteline one.
You could try bending the brackets that hold the intercooler, so that it sits a little lower in the engine bay??
Andy
Last edited by Fuzz; 19 October 2005 at 08:40 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Flat4x4-again
General Technical
2
29 September 2015 06:32 PM