URGENT!!! Advice on fitting anti-lift to Bugeye
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Feb 2003
Location: 2.1 Spec-C .......Pimms O'clock!!
Posts: 2,726
Likes: 0
Received 0 Likes
on
0 Posts
URGENT!!! Advice on fitting anti-lift to Bugeye
I have a 2002 WRX and need some advice/pictures etc.. on where the Whiteline ALK fits.
Need to do this on Sunday and have been searching like mad to find some good pictures of one fitted. Found the Whiteline instructions on their site quite good, but still not entirely sure where all the spacers and washers go (there are more parts for the newshape than there are for the classic ).
Any help will be VERY MUCH appreciated
Ross
Need to do this on Sunday and have been searching like mad to find some good pictures of one fitted. Found the Whiteline instructions on their site quite good, but still not entirely sure where all the spacers and washers go (there are more parts for the newshape than there are for the classic ).
Any help will be VERY MUCH appreciated
Ross
#2
Scooby Regular
Join Date: Apr 2003
Location: Location: Location:
Posts: 1,097
Likes: 0
Received 0 Likes
on
0 Posts
Is this the instruction manual you have?
http://www.whiteline.com.au/docs/ins...08b_KCA359.pdf
You'll put the bolts and washers in locations 6, 5, 11, 10, 9.
Location 6 is towards the rear of the car, location 9 is at the front of the car. The smaller washers fit at the front, and increase in size towards the rear.
The large bar is U shaped, it also attaches to the radiator, and you may have to loosen these bolts to get it to drop down enough at the back to fit the large block in.
Also note: the alloy mounts are labeled TOP RIGHT / TOP LEFT for a reason they do fit upside down, but not very well .
The bolts will be very tight, you may need an extension arm on your ratchet socket. If you don't have a torque wrench you'll need to check the bolts are still tight after a week or so.
http://www.whiteline.com.au/docs/ins...08b_KCA359.pdf
You'll put the bolts and washers in locations 6, 5, 11, 10, 9.
Location 6 is towards the rear of the car, location 9 is at the front of the car. The smaller washers fit at the front, and increase in size towards the rear.
The large bar is U shaped, it also attaches to the radiator, and you may have to loosen these bolts to get it to drop down enough at the back to fit the large block in.
Also note: the alloy mounts are labeled TOP RIGHT / TOP LEFT for a reason they do fit upside down, but not very well .
The bolts will be very tight, you may need an extension arm on your ratchet socket. If you don't have a torque wrench you'll need to check the bolts are still tight after a week or so.
Last edited by Jiggerypokery; 18 February 2005 at 10:10 AM.
Thread
Thread Starter
Forum
Replies
Last Post
JonMc
Subaru Parts
22
06 February 2016 09:50 PM