New spring not sitting flat
#1
Scooby Regular
Thread Starter
New spring not sitting flat
Blob wrx
Fitting tein springs and the top doesnt sit flat on the cup, I've fitted lowering springs before and sure I've never had this before, the bottom is located fine and so is the top until I tighten the nut, when on the car and compressed it may be fine but thought I would ask first
Should add I removed and tried refitting and it always ends up like this 🤔
Fitting tein springs and the top doesnt sit flat on the cup, I've fitted lowering springs before and sure I've never had this before, the bottom is located fine and so is the top until I tighten the nut, when on the car and compressed it may be fine but thought I would ask first
Should add I removed and tried refitting and it always ends up like this 🤔
#4
Scooby Regular
Thread Starter
Thanks for the replies
Yes the top hat is the 1 that came off
As it current is the wider part of the spring is at the bottom, can't imagine the smaller side at the bottom?
I'll turn it around later and take a photo
Yes the top hat is the 1 that came off
As it current is the wider part of the spring is at the bottom, can't imagine the smaller side at the bottom?
I'll turn it around later and take a photo
#5
Scooby Regular
Thread Starter
Spring is definitely the correct way round, when turned the other way it won't fit in the top hat as it's too big.
Comparing the old and new springs the appear to be identical in size so I'm at a loss as to why it won't seat properly
Comparing the old and new springs the appear to be identical in size so I'm at a loss as to why it won't seat properly
#6
Scooby Regular
To me it looks as if the spring seat is 180 degrees out.
Have you put the conicle washer (9) on upside down locking the spring seat to the top mount?
Have you put the conicle washer (9) on upside down locking the spring seat to the top mount?
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post