braided brake lines
#1
braided brake lines
Now I'm re-doing my brake lines my current setup is up for sale.
This setup is used on a 2 port master cylinder to which the front port has a 2 way banjo that go's straight onto the front brakes and the rear port routes off through bulkhead and onto the bias valve and back out onto a 2 way block that sends the fluid to the rear brakes.
There is enough length on the bias line to reach to the glove box area as that's where I had intended to run it.
Everything mentioned and pictured included,bargain.
£100 posted
[IMG][/IMG]
[IMG][/IMG]
This setup is used on a 2 port master cylinder to which the front port has a 2 way banjo that go's straight onto the front brakes and the rear port routes off through bulkhead and onto the bias valve and back out onto a 2 way block that sends the fluid to the rear brakes.
There is enough length on the bias line to reach to the glove box area as that's where I had intended to run it.
Everything mentioned and pictured included,bargain.
£100 posted
[IMG][/IMG]
[IMG][/IMG]
Thread
Thread Starter
Forum
Replies
Last Post