AET turbo's gt30
22 November 2012, 08:58 PM
#1
Scooby Regular
Thread Starter
iTrader: (67)
Join Date: Oct 2007
Location: w,yorkshire
Posts: 4,061
Likes: 0
Received 0 Likes
on
0 Posts
AET turbo's gt30
AET turbo's standered position gt30 turbo.this turbo has only ever seen actuator pressure whilst running the motor in.turbo should be good for 450-500 bhp depending on mods + fuel used.comes with braided oil feed pipe and water pipes and a silicone inlet pipe with stainless hard pipe bend.so ready to fit.£700
Last edited by bigarf; 01 December 2012 at 08:24 AM.
25 November 2012, 01:25 PM
#6
Scooby Regular
Thread Starter
iTrader: (67)
Join Date: Oct 2007
Location: w,yorkshire
Posts: 4,061
Likes: 0
Received 0 Likes
on
0 Posts
Trending Topics
14 December 2012, 01:07 PM
#15
Scooby Regular
iTrader: (6)
Join Date: Sep 2006
Location: Leeds
Posts: 490
Likes: 0
Received 0 Likes
on
0 Posts
Did a run last night on gtx3071 from Aet standard position with 20% meth and did over 500 at 1.9 bar on a 2.0
Last edited by turboturner; 14 December 2012 at 01:09 PM.
14 December 2012, 09:03 PM
#18
Scooby Regular
Thread Starter
iTrader: (67)
Join Date: Oct 2007
Location: w,yorkshire
Posts: 4,061
Likes: 0
Received 0 Likes
on
0 Posts
there cracking little turbo's are these,just not as well known as the likes of the md range.they all seem to deliver the goods when it comes to making good power.
15 December 2012, 08:21 AM
#20
Scooby Regular
Thread Starter
iTrader: (67)
Join Date: Oct 2007
Location: w,yorkshire
Posts: 4,061
Likes: 0
Received 0 Likes
on
0 Posts
i dont have a 20g to compare it to size wise so carnt answer that one.the milage i would say will be around 3000 miles but all of that has been only on actuator pressure.as the motor was being run in.it should be a straight fit.
Thread
Thread Starter
Forum
Replies
Last Post
