AET turbo's gt30
 

AET turbo's standered position gt30 turbo.this turbo has only ever seen actuator pressure whilst running the motor in.turbo should be good for 450-500 bhp depending on mods + fuel used.comes with braided oil feed pipe and water pipes and a silicone inlet pipe with stainless hard pipe bend.so ready to fit.£700
http://i336.photobucket.com/albums/n...500/006-13.jpg
http://i336.photobucket.com/albums/n...500/007-17.jpg
http://i336.photobucket.com/albums/n...500/008-10.jpg
http://i336.photobucket.com/albums/n...500/009-11.jpg

Btt

What's lowest you will take? I live local. Thanks

pm me an offer mate.:thumb:

What would this be like on a classic with a ej257 and v3 heads running on shells best. Would it be laggy ? And would it make around 450

what power it will make all depends on other mods you have and what boost you want to run.but i would say it would make for a cracking turbo on a 2.5l.and no i carnt see it being laggy on a 2.5l either.:)

If i had cash ready i would take this turbo of you. I have 2.5 fully forged and was looking for a gt30 stock location. GLWS mate.

btt

btt

btt

btt

btt

we used a billet version of this on a 2.5 ( aet gt30 ) and made 504bhp @ 1.75 bar on 10% meth as a guide if its any use to anyone

Any figures on 2.1 AVCS?

Thanks

Did a run last night on gtx3071 from Aet standard position with 20% meth and did over 500 at 1.9 bar on a 2.0:)

Thanks for info!

Are you happy with spool?
Probably would be a bit better on stroker 2.1 then on 2.0 :)

Thanks
Sani

Spool up is great, hit max torque at 4400rpm...;)

there cracking little turbo's are these,just not as well known as the likes of the md range.they all seem to deliver the goods when it comes to making good power.

What is the mileage? Any play in the shaft? How big size wise is this compared to an andy Forrest 20g? Will I need to shave some of the block away?

Cheers

i dont have a 20g to compare it to size wise so carnt answer that one.the milage i would say will be around 3000 miles but all of that has been only on actuator pressure.as the motor was being run in.it should be a straight fit.

Guessing this is sold :)

yes mate,it went ages ago.