PaulZero

iTrader: (2)

Hi Guys i have the prototype set of fog light surrounds up for grabs £75 with free shipping to mainland UK





Also a Carbon A pillar double pod 60mm £50 free p&p to mainland UK





These parts are proper 3k Twill weave carbon fibre not wrapped

M17CH

Hi mate any luck with the blobeye interior parts?

Mitch

v6wrx

iTrader: (2)

Look nice how many layers of carbon are they? Did you use clear gell?

yallahyimshi

how is the pod thingy mounted? does it fit a forester?

Cannon Fodder

iTrader: (100)

Do you do a single 60mm pod?

PaulZero

iTrader: (2)

Mitch the blobeye bits are being prototyped as we speak.

v6wrx there two layers of carbon in this and yes a clear Gel with a UV lacquer over it

yallahyimshi to be honest i am not sure :0 i used one of the readily available ones as a pattern so perhaps one of the guys who have one fitted could answer??

PaulZero

iTrader: (2)

Cannon Fodder i may end up doing a range of these depending on demand

Cannon Fodder

iTrader: (100)

I'll definitely have one if they become available plus some other bits as well.

Wagon Gaz

iTrader: (18)

Very tempted are they bad to fit?

Rice Rocket

iTrader: (23)

Nice work on them!


Ricey

Cannon Fodder

iTrader: (100)

I've seen a spoiler and grille supplied by PaulZero and they are superb quality.

scoobjam74

iTrader: (11)

hi bud do you do carbon covering of components as i have a 22b vent off a classic bonnet i need covering in carbon ? cheers

yallahyimshi

thanks would be nice to know if it would fit!

kenc

iTrader: (6)

Are they Blob eye Fog covers?

PaulZero

iTrader: (2)

Kenc, Unfortunately not or they would be on my 05 WRX Blob. I was told the originals i used were from a Hawk eye but i could be wrong

PaulZero

iTrader: (2)

Can anyone give us the low down on how the A pillar pod mounts???

Rice Rocket

iTrader: (23)

The one above will either just screw in or double sided tape, you can get ones that are the full length of the a pillar and again they screw into the OE part or you can get a complete replacement a pillar which replaces the OE part completely.

HTHs
Ricey

PaulZero

iTrader: (2)

Cheers Ricey. Did you get that yallahyimshi???

jono300

iTrader: (8)

Any idea on time scale on the finished A pillars paul ?? you got a list off blobeye interior parts you are planning to have done / sell ??

PaulZero

iTrader: (2)

I'll have a look and send you a list, i dont want to be seen as a trader here so i have to be careful not to upset the powers. If you want to contact me on paul@zero-limits.co.uk

jono300

iTrader: (8)

No probs totally understand mate, it was me who sent you the A pillars for the fabrication off the carbon parts, as I say just wondered if you had a rough idea how long till finished ??

PaulZero

iTrader: (2)

Jono sorry mate i get lost in all this forum names and the real world lol. The A pillars are being moulded as we speak but i would think about 3 weeks until i can get the first set to test fit.

jono300

iTrader: (8)

Not a problem mate thats fine more than happy to waitt as am sure if they turn out to be like the rest off your stuff will be top quality !!

thanks paul.

john