Newage 4 pots (refurbished) with Godspeed 335mm fitting kit (no discs)
#1
Newage 4 pots (refurbished) with Godspeed 335mm fitting kit (no discs)
I have just upgraded to K sports so have my previous brake setup for sale.
I am selling;
- recently refurbished 4 pot calipers (like new)
- the fitting kit you need for the godspeed 335mm kit minus discs
- bluestuff pads with around 500 miles of use
The calipers have recently been completely refurbished with new stainless steel pistons and O rings (kit supplied by godpseed), sand blasted and powder coated in red, previous to this they had about 48K on them.
I was using the godspeed 335mm kit, but the discs recently wore out after I had fitted a new set of bluestuff pads, the discs caused the pads to overheat which is why the paint has bubbled off in places. The discs went whilst I was out on track (yes it was hairy!!) so previous to this the pads had only had around 500 miles on them. I have spoken with Godspeed who have assured that the pads will be fine.
You will also get the hubs which have the mounting holes drilled out to 14mm, I had to source a new pair of hubs to get my K sports fitted, the wheel bearings are absolutely fine.
I found this kit an excellent upgrade to the standard 4 pots especially when used with braided lines, I have done many track days with this setup and never suffered any fade, and have they have often out performed brembos.
You have everything you need to fit this kit minus the discs, which are £300 new from godspeed. The calipers are like new and you can sell your calipers!
I am looking for £300 for the lot, based near Bristol. Collection only unless you arrange a courier.
I am selling;
- recently refurbished 4 pot calipers (like new)
- the fitting kit you need for the godspeed 335mm kit minus discs
- bluestuff pads with around 500 miles of use
The calipers have recently been completely refurbished with new stainless steel pistons and O rings (kit supplied by godpseed), sand blasted and powder coated in red, previous to this they had about 48K on them.
I was using the godspeed 335mm kit, but the discs recently wore out after I had fitted a new set of bluestuff pads, the discs caused the pads to overheat which is why the paint has bubbled off in places. The discs went whilst I was out on track (yes it was hairy!!) so previous to this the pads had only had around 500 miles on them. I have spoken with Godspeed who have assured that the pads will be fine.
You will also get the hubs which have the mounting holes drilled out to 14mm, I had to source a new pair of hubs to get my K sports fitted, the wheel bearings are absolutely fine.
I found this kit an excellent upgrade to the standard 4 pots especially when used with braided lines, I have done many track days with this setup and never suffered any fade, and have they have often out performed brembos.
You have everything you need to fit this kit minus the discs, which are £300 new from godspeed. The calipers are like new and you can sell your calipers!
I am looking for £300 for the lot, based near Bristol. Collection only unless you arrange a courier.
Trending Topics
#16
THE braking specialist
iTrader: (259)
You don't need to drill the hubs out to fit this kit , you need to run a 14mm tap through the original 12mm holes to tap a thread into them to fit the brackets in place , going back to standard at a later date will not cause any problems as the hole is still 12mm , albeit with a 14mm thread cut into it.
#17
You don't need to drill the hubs out to fit this kit , you need to run a 14mm tap through the original 12mm holes to tap a thread into them to fit the brackets in place , going back to standard at a later date will not cause any problems as the hole is still 12mm , albeit with a 14mm thread cut into it.
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
Matt_182
Wheels, Tyres & Brakes
19
07 October 2015 01:05 PM
Ste333
Wheels, Tyres & Brakes
7
11 September 2015 11:24 AM