Ver 1/2 Apexi Power FC and Phase 2 740cc Injectors
#1
Ver 1/2 Apexi Power FC and Phase 2 740cc Injectors
Time to start offloading some parts that are no longer required.
Apexi Power FC and Commander for early four plug cars versions 1 and 2. In excellent condition. Removed today in full working order. It has been in my RA and as such has had very little use. Comes complete with a bracket I made up to allow it to be fitted in the same location as the standard ECU. This really is an excellent ECU, cheap to map and loads of useful info via the hand commander which can also be used to set virtually all the parameters. Looking for £450
Also have a cage that will fit the Power FC or a standard ECU. Allows the ECU plugs and hand commander plug to be plugged in without removing ECU from the cage.
Looking for £35
Set of Nismo 740cc phase 2 injectors, fitted to a set of phase one fuel rails converted to AN -6 ends. Fitted with a set of Carl Davey Injector adapters. Again removed from my RA so have seen very few miles. I bought the injectors new and are genuine 740cc injectors not a lower capacity flowed to 740cc. There is little point sticking a set of say 550cc injectors in your car then realising later that you have run out of headroom, fit a set of 740cc injectors and have the duty cycle changed by your mapper to suit the flow you require. If you run out of headroom with these, which I doubt, they can be flowed by Mark at Lateral to almost 1000cc. The phase 2 Injectors are significantly better all round when compared to a phase 1 Injector.
Injectors and Rails sold
I am happy to take payment by paypal but it either needs to be as a gift or the buyer pays the fees.
Apexi Power FC and Commander for early four plug cars versions 1 and 2. In excellent condition. Removed today in full working order. It has been in my RA and as such has had very little use. Comes complete with a bracket I made up to allow it to be fitted in the same location as the standard ECU. This really is an excellent ECU, cheap to map and loads of useful info via the hand commander which can also be used to set virtually all the parameters. Looking for £450
Also have a cage that will fit the Power FC or a standard ECU. Allows the ECU plugs and hand commander plug to be plugged in without removing ECU from the cage.
Looking for £35
Set of Nismo 740cc phase 2 injectors, fitted to a set of phase one fuel rails converted to AN -6 ends. Fitted with a set of Carl Davey Injector adapters. Again removed from my RA so have seen very few miles. I bought the injectors new and are genuine 740cc injectors not a lower capacity flowed to 740cc. There is little point sticking a set of say 550cc injectors in your car then realising later that you have run out of headroom, fit a set of 740cc injectors and have the duty cycle changed by your mapper to suit the flow you require. If you run out of headroom with these, which I doubt, they can be flowed by Mark at Lateral to almost 1000cc. The phase 2 Injectors are significantly better all round when compared to a phase 1 Injector.
Injectors and Rails sold
I am happy to take payment by paypal but it either needs to be as a gift or the buyer pays the fees.
Last edited by Arch; 07 June 2011 at 03:15 PM. Reason: Injectors and rails sold
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
bluebullet29
General Technical
9
05 October 2015 02:17 PM
Pro-Line Motorsport
Car Parts For Sale
2
29 September 2015 07:36 PM