Japspeed FMIC for new age
#1
Japspeed FMIC for new age
De-tuning my car somewhat, so I've gone back to a STI TMIC, so my old Japspeed FMIC kit is up for sale. It was fitted to my 2003 WRX.
The core is still in great condition, and the pipework is good too.
One of the pipes rubbed against some body work, so I've welded it back up (see pics), but apart from that the pipework is also in good condition. The repair will be invisible once fitted, as it's facing down and to the back. The rubbing occurred where the pipe goes into the wheel arch on the drivers side).
Looking for 130, ideally collected from Bromley in Kent (our SE London). I can also send, but as it will have to go as two separate parcels (core + pipework separately), delivery will be around 20 pounds.
Front of core:
Rear of core:
Repair - before:
Repair - after:
The core is still in great condition, and the pipework is good too.
One of the pipes rubbed against some body work, so I've welded it back up (see pics), but apart from that the pipework is also in good condition. The repair will be invisible once fitted, as it's facing down and to the back. The rubbing occurred where the pipe goes into the wheel arch on the drivers side).
Looking for 130, ideally collected from Bromley in Kent (our SE London). I can also send, but as it will have to go as two separate parcels (core + pipework separately), delivery will be around 20 pounds.
Front of core:
Rear of core:
Repair - before:
Repair - after:
Last edited by Henrik; 15 January 2019 at 05:46 PM.
#6
Hmm, so I am under the impression that it will fit up to 2007 (ie including hawk), given that the bug/blob/hawk are basically the same chassis's underneath the body.
It has the usual caveats that you obviously will need to cut some of the bumper etc (same as any fmic kit), but I do think it should fit.
if you're interested, I will take some more photos and also make sure I definitely have all the hose clips etc (hoping to be able to get out into the workshop this weekend again)
It has the usual caveats that you obviously will need to cut some of the bumper etc (same as any fmic kit), but I do think it should fit.
if you're interested, I will take some more photos and also make sure I definitely have all the hose clips etc (hoping to be able to get out into the workshop this weekend again)
#7
Regarding clips, I do have a hose clip for every joint, except for the one to the throttle body (then again, the one that comes off with the top mount intercooler will fit here). A couple of the clips are worm drive, however, as I managed to break one mikalor ("style") clamp, and loose another two.
Also, new lower price (130 collected, 150 posted).
Also, new lower price (130 collected, 150 posted).
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Ed@Japspeed
Trader Announcements
617
20 June 2018 07:45 AM