de-tango and carbon side markers
#1
de-tango and carbon side markers
Decided to detango the bug. Wanted carbon side makers to compliment the clear indicators but they are very pricey. So, with a bit of 3M carbon wrap and the orginal side markers, I did a homemade carbon effect side marker. End results are very good - well chuffed.
Now let's see if it falls off in these high temps!
Now let's see if it falls off in these high temps!
#4
No air bubbles in this piece of high quality bodgery!
I took my time, trimmed carefully and applied heat from the wife's hairdryer to within an inch of its life. The ridge you can see is a raised area of plastic on the original side marker. What you could do to get rid of any ridges (there are others too) is sand it all down prior to wrapping. I was nervous about doing this because if the wrap went wrong I needed functioning side markers at the end of it. If the wrap lasts and I'm happy with it then I may well buy a very cheap amber set and re-wrap to eliminate all ridges, but that would be being a bit ****, as from a reasonable disatance you cannot see any faults at all.
I took my time, trimmed carefully and applied heat from the wife's hairdryer to within an inch of its life. The ridge you can see is a raised area of plastic on the original side marker. What you could do to get rid of any ridges (there are others too) is sand it all down prior to wrapping. I was nervous about doing this because if the wrap went wrong I needed functioning side markers at the end of it. If the wrap lasts and I'm happy with it then I may well buy a very cheap amber set and re-wrap to eliminate all ridges, but that would be being a bit ****, as from a reasonable disatance you cannot see any faults at all.
#11
Got mine from:
http://www.undergroundgraphics.com/3...ck/p-728-2181/
I went for the 30x60 piece - plenty of room for a second or even a third try if you muck it up.
http://www.undergroundgraphics.com/3...ck/p-728-2181/
I went for the 30x60 piece - plenty of room for a second or even a third try if you muck it up.
Last edited by sprigeteer; 10 June 2011 at 07:04 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Pro-Line Motorsport
Car Parts For Sale
2
29 September 2015 07:36 PM