Blobeye front bumper question
#1
Blobeye front bumper question
Wont be long until I'm getting my splitter painted and fitted which is great I cant wait
However it leaves me with a slight problem re: my zunsport lower grill. The splitter has a lip that goes over the bottom of the existing bumper and gets bonded on, meaning that the lower gap that the grill is designed to fit will now be smaller (see blue arrow) and I'm assuming the grill wont fit
If it doesn't fit, I'm wondering whether the black plastic bit (excuse my technical terminology!) behind the numberplate (as you look at the bumper from the front) could be cut to make the extra gap see (red arrow)
Need some advice please!
However it leaves me with a slight problem re: my zunsport lower grill. The splitter has a lip that goes over the bottom of the existing bumper and gets bonded on, meaning that the lower gap that the grill is designed to fit will now be smaller (see blue arrow) and I'm assuming the grill wont fit
If it doesn't fit, I'm wondering whether the black plastic bit (excuse my technical terminology!) behind the numberplate (as you look at the bumper from the front) could be cut to make the extra gap see (red arrow)
Need some advice please!
#6
Scooby Regular
iTrader: (1)
Join Date: Aug 2009
Location: birmingham
Posts: 300
Likes: 0
Received 0 Likes
on
0 Posts
you can cut it out have just done mine to allow for front mount intercooler, used an air saw but it does cut with a stanley knife bekeive it or not!! just need a steady hand and lots of patience!!
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
blockhead
Subaru Parts
19
07 November 2015 11:50 PM
MH-Racing
Subaru Parts
18
18 October 2015 04:49 PM