Vortex Generator - fitting?
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Feb 2008
Location: Bristol
Posts: 249
Likes: 0
Received 0 Likes
on
0 Posts
Vortex Generator - fitting?
Just bought a carbon fibre Vortex Generator and I wonder if it's best to use 3M tape all round or something like Tiger Seal adhesive?
I rarely drive on the motorway and therefore the car rarely goes above 50mph!
Any advice would be appreciated
I rarely drive on the motorway and therefore the car rarely goes above 50mph!
Any advice would be appreciated
#3
mines stuck down with tape and has been tested at speed no problems, though i am aware of someone on here that said his flew off but as long as you clean both surfaces well and maybe use a hairdryer to heat the roof surface up i think you'll be ok
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
JonMc
Subaru Parts
22
06 February 2016 09:50 PM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM