Splash Guard Fitment...
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Jan 2007
Location: Oo'p Norf
Posts: 873
Likes: 0
Received 0 Likes
on
0 Posts
Splash Guard Fitment...
I recently bought some splash guards for a classic off Ebay... The guy who I bought them off said they didn't come with any fitting parts, other than the foam glue strips on the inside of them.
On the front face of the guards is a hole, which lines up perfectly with the fasteners for rear and side skirts.
This is fine for the rear skirts which are held in place by a bolt, this can be replaced with a slightly longer bolt and washer. However the front of the side skirt is held in place by plastic pop though clip, does anybody have any ideas how this front splash guard should be secured, as I don't fancy just relying on the foam glue strips.
cheers..
On the front face of the guards is a hole, which lines up perfectly with the fasteners for rear and side skirts.
This is fine for the rear skirts which are held in place by a bolt, this can be replaced with a slightly longer bolt and washer. However the front of the side skirt is held in place by plastic pop though clip, does anybody have any ideas how this front splash guard should be secured, as I don't fancy just relying on the foam glue strips.
cheers..
Last edited by swampster; 12 April 2008 at 09:16 PM.
Thread
Thread Starter
Forum
Replies
Last Post