When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Full Power map, diff left in AUTO Press and hold the VDC button for a couple of seconds to disable the traction control etc.
Clutch in 1st gear on a flat surface, Build the revs for a couple of seconds to get some boost and just slip your foot off the clutch. All I did with mine when I had it, It used to set off sideways with lots of smoke off the tyres, Then flatfoot shift up the box. Makes for pretty rapid progress
Got launch control added to the map mate , the cruise control buttons raise and lower the RPM
So just turn the traction control off ? Would rather smoke tyres than the clutch
Other than eBay, are there any places that I can buy a rear passenger side clear reversing light unit, the inner lense on the hatch door? Mine is leaking, can't stop it, and prefer not to drill. Thanks
Other than eBay, are there any places that I can buy a rear passenger side clear reversing light unit, the inner lense on the hatch door? Mine is leaking, can't stop it, and prefer not to drill. Thanks
Has the foam seal on the rear of the light been compromised ? that's usually the only place they let water in
Has the foam seal on the rear of the light been compromised ? that's usually the only place they let water in
the foam seemed OK when I took it off. Are there holes behind the foam, or does the foam act as a gasket? I got an exploded diagram from dealer that suggests that the foam is available separately. Would that be a solution, Rob? Thanks for replying, you are a great link with the main network.
the foam seemed OK when I took it off. Are there holes behind the foam, or does the foam act as a gasket? I got an exploded diagram from dealer that suggests that the foam is available separately. Would that be a solution, Rob? Thanks for replying, you are a great link with the main network.
If you change the AC belt you need the little tool to do it as there's no tensioner, I got caught out by this when I replaced my AC pump! The pi$$ take is that the belt is about 9 quid but the belt and tool is 50
the foam seemed OK when I took it off. Are there holes behind the foam, or does the foam act as a gasket? I got an exploded diagram from dealer that suggests that the foam is available separately. Would that be a solution, Rob? Thanks for replying, you are a great link with the main network.
The foam acts as a gasket between the lamp & the body of the vehicle. The foam aka Packing is available separate. Not very common that a light would leak unless its cracked.
Ah ok, glad I asked now - thanks Rob. I've ordered and will have a go on Thursday, is it a fairly straight forward job or anything to look out for?
Seemed straightforward, but then again I was watching my mate do most of the work
We'd tried without the tool on the AC belt and wasted an hour before deciding we needed the tool to help. Once he had it then it only took about a quarter turn of the crank to pop the belt on, about 10 seconds work
Translation:
Set of 4 lateral links with pillow ball bush. By changing the rubber bush inside the lateral link to a pillow ball bush, we improve friction and camber stiffness when stroking, sharp handling at cornering, and realize linear suspension characteristics from turn-in to rising. Pillow ball bush (2 places × 2) press fitted.
Last edited by Don Clark; 21 January 2017 at 10:27 AM.