Hi, I have seen a lot of info on this site about sigma alarms, unfortunately I don't have a scooby I have a Mitsubishi L200, the problem I have is that since my mate borrowed the vehicle and left the lights on making the battery go flat only one of my 2 sigma fobs works, i have tried to reprogram the fobs using *17856*91*2# on the keypad but only one will work. Not sure on the alarm model the vehicle is on an S plate 1999, on the back of the fob it says "mpt 1340 wt licence exempt". I have purchased 2 other fobs off ebay 1 the same and another with "type ac 38" on the back. Any ideas will be much appreciated.

 

What Sigma model is it ?

Ian

 

I think it is the m series not sure on the model I just have an m series operating instruction book that came with the vehicle. The fob only has one button and one light if that helps.
Thanks

 

So you've followed these instructions?

http://www.scoobypedia.co.uk/index.p...RemoteControls

and the LED flashed and siren beeped for each fob when pressed??

Have you replaced the battery in the non working fob??

 

Yeah I tried that the dash led flashes but the siren doesn't beep for the one that works, and nothing happens when I press the other fobs , as I mentioned one of the fobs I have used to work until the battery on the vehicle went flat when it stopped working. Just need to get another fob working as a spare as I don't have the pin number for the alarm.

 

Changing your PIN
- Arm and then Disarm the system using a working Radio Key.
- Within 30 seconds of disarming, type into the keypad: *17856*92*wxyz*wxyz# (where wxyz is your new PIN code)
- Arm the system with the Radio Key
- You should now be able to disarm the system using the new PIN code


Worth looking through Sigma Sams thread, may give an insight to your problem............

http://forums.sidc.co.uk/topic/96215...larm-problems/

 

Thanks for that, I will try that tomorrow.