I want to add a clifford G5 Led (gives the look) can i just use the wires from the standard red led? Is this 3v or 12v

 

clifford blue leds are 3v

 

You can get 12v too, so i didnt know if i would need 3v or 12v as i would just want to join to the existing wiring

 

i just removed the clifford led and put a 12v pulsing one in there in blue of course and works a treat, no one will see a difference,

But you excisting one will be 3v

 

if you have an aftermarket alarm ou will need to check the led voltage from the alarm, if it is 3v then just wire a clifford one up, if no alrm then you will need a flashing relay and a 470ohm resiter

 

Cheers mate im using the stock alarm. Which has a little red Led next to the clock, When the gauges were installed this was cut off, I was going to re attach the red led but thought if i just attached a Clifford led it will make people think it has a top end alarm

 

i have wired my clifford led to that and it will flash as well just like the red on would, I have mounted it just to the right of the stearing wheel is were the headlight adjuster is, i have put the red led back in just to fill the hole were the clock is as wel