fitting the Cifford-horn in a WRX-MY01
#1
Where does the Cliiford-fitting-expert put the Horn from the Cifford concept600 in the New MY01WRX ??
Overhere in Holland (no aircon standard)they fit them on that spot, the other spot to place the horn is above the Turbo/downpipesection,......Much TO HOT !!!!
Wich heat can it tolerate ???
Overhere in Holland (no aircon standard)they fit them on that spot, the other spot to place the horn is above the Turbo/downpipesection,......Much TO HOT !!!!
Wich heat can it tolerate ???
#2
It should be possible to mount it on the bulkhead, just toward the nearside (passenger side of a right-hand drive car), kind of behind the intercooler pointing downwards. This is the spot I put them in whether or not there is aircon plumbing in the way. It's a little tricky, but with patience, a right-angled drill and a bit of grunting, it goes in very neatly and is well away from any high temperatures
#3
Scooby Regular
Join Date: Oct 2000
Location: the fastest rentals in town......0-100mph in 10 seconds
Posts: 1,401
Likes: 0
Received 0 Likes
on
0 Posts
Do you really think this is a good idea advertising to all and sundry where certain parts are located?
It's bad enough trying to keep them away in the first place.
It's bad enough trying to keep them away in the first place.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
JonMc
Subaru Parts
22
06 February 2016 09:50 PM
matt12
ScoobyNet General
64
16 September 2015 09:16 PM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM