Let the project begin
#1
Let the project begin
I have now just started rebuilding my02 sti so ripping the engine out for a 2.1 build and was looking at a rotated setup but just been on scoobyclinics website and see a GT30 or a GT35....... which is the recommended turbo to get or that ppl use?
#5
Scooby Regular
iTrader: (7)
Hi there
If you are going with 2.1L,assume you will be running AVCS heads,if yes I would go down the route of the GT30,on 2.1L will be nice and spooly
Second bit what power you are thinking to run?! And from this I would go and decide which is best option,plus you are looking more for track or drag strip etc.
Jura
If you are going with 2.1L,assume you will be running AVCS heads,if yes I would go down the route of the GT30,on 2.1L will be nice and spooly
Second bit what power you are thinking to run?! And from this I would go and decide which is best option,plus you are looking more for track or drag strip etc.
Jura
Trending Topics
#10
Scooby Regular
iTrader: (7)
Depends on budget,speak to few builders here and ask them for spec
I would go with Mahle Pistons(just wish Cosworth pistons are available too for 2.1)
Rods: K1,Carrillo, Cosworth etc
Crank:EJ257
HG:Cosworth
Headstuds: 11mm Cosworth 260k psi if budget allow get 14mm headstud conversion
OEM Gasket rebuild kit
ACL Race Bearings
plus few other bits and bobs,really speak with engine builders here,I'm sure they will spec for you nice engine which will hold that power without the problem on longer run
Jura
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Phil3822
General Technical
0
30 September 2015 06:29 PM