MAP Sensor position and Fitting ? and type ?
28 December 2011, 07:33 PM
#1
Scooby Regular
Thread Starter
iTrader: (4)
Join Date: May 2010
Posts: 360
Likes: 0
Received 0 Likes
on
0 Posts
MAP Sensor position and Fitting ? and type ?
Getting the little bits together to get rid of the MAF, on my 93 WRX, I will need to replace the MAP sensor and I was thinking to move its position. I recon its better to have a short run to the sensor to get the best reading?
Also what sensor ? 3 Bar or something smaller. Planned boost will not be 2Bar, so I was thinking 2 Bar as it will give better resolution to the readings or dose it not matter ?
If I run an ESL , then the MAF connection can be used as intake temp I think, just woundering whats the best set up ?
Also what sensor ? 3 Bar or something smaller. Planned boost will not be 2Bar, so I was thinking 2 Bar as it will give better resolution to the readings or dose it not matter ?
If I run an ESL , then the MAF connection can be used as intake temp I think, just woundering whats the best set up ?
28 December 2011, 09:52 PM
#2
Scooby Regular
Delco 3 bar sensor is the most popular solution and it's fairly easy to fit.
Martyn
Martyn
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
matt12
Engine Management and ECU Remapping
4
14 September 2015 09:36 AM