Iv just bought a classic with a simtek with 2 map setting but I can't remember for the life of me how to change between1 and 2 can anyone help

 

I'm using solaris / Syvecs ecu and it's a **** to twist on mine
Before you do though mate what's the difference between maps ???
Make sire it's not fuel etc if you've not changed the fuel :-)

 

Theres usually a button for it mate. Or I believe it can be done with the accelerator? (That maybe just launch control)

 

If on a switch then when switch is grounded map 2 is enabled.
If no switch is fitted then throttle pedal activates as follows:
1.With Ign OFF fully depress throttle pedal.
2.Turn In ON keeping pedal depressed but don't crank engine.
3.Wait for 5 secs and Tacho will go to 1(000) or 2(000) indicating which map is active.
4.If active map is required map then release pedal and start engine.
5.If map is to be changed then release pedal, then fully depress again.Wait until Tacho goes to required map then release pedal and start engine.

Steve

 

It's on the accelerator thnaks mate. Tried what you said and worked thanks, top man

 

sorry to add to the thread, just a quick q. is it easy to get it converted to a switch, if so what does it usually cost?
Cheers.

 

Cost of switch and 10 seconds to change in software to tell it to use switch not throttle...

 

Should be free to change to switch if you return to original mapper

 

Nice one thanks