diy heatshield
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Jun 2010
Location: surrey
Posts: 1,710
Likes: 0
Received 0 Likes
on
0 Posts
diy heatshield
hi all , it seems induction kit heat shields are hard to come by ? so made my own out of aluminium to join the 3 pieces together i simply drilled and riveted . then to finish managed to blag some rubber strips from metal works factory and slotted onto the sharp edges . also , if anyone wants to cut aluminium easily without sawing " my metal is 2mm thick " simply use a sharp stanley knife cut at least 3 times then gently bend up and down . it gives a perfect cut better than hacksaw ! just discovered it .
#3
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Jun 2010
Location: surrey
Posts: 1,710
Likes: 0
Received 0 Likes
on
0 Posts
also fibre glassed a vent to the inside of my front bumper , which i can fit the duct pipe onto . only when i went to fit the bumper back on i discovered it wouldnt fit and had to cut loads of it out to get it on !!!
Thread
Thread Starter
Forum
Replies
Last Post
oilman
Trader Announcements
15
01 October 2015 11:55 AM