Hi guys,
I've got a 3" Miltek system on my car comprising of down pipe, middle section and rear box. Great system but a little quiet for my taste. I want to change just the rear box to increase noise slightly but want to keep the rest of the Miltek system in place.
I have been doing some research to find out if another back box will mate up with the Miltek middle section but can't get a definitive answer. Some have said yes it will fit and others have said it won't. I don't really want to change the entire system unless I really have too.
Does anybody know the answer to my question for sure.

Thanks, Matt..

 

It's probably quiet to you as your car is well insulated, it may be very loud to everyone else though!
I had it with my first scoob with the ppp fitted, sounded quiet but not bad on full chant, heard it one day when the garage had it in because of the boost solenoid and though "that sounds good!" only to see it was mine
You could always speak to miltek to see if they do a louder backbox?

Tony

 

It is quiet buddy.
Check my weight figures above, no insulation to be seen anywhere, lol.
Had on Zens rollers a few times too and stood with the car at full chat.
Spoke to Miltek yesterday and they have apparently stopped production of exhausts for classics, and they wouldn't/couldn't tell me if a different back box would mate up.

 

I have the Milltek 3" with no cats, quiet in the car, but when the wife goes out in it, it sounds much louder from outside

 

the only thing i could off is go to powerflow exhausts and get them to do a back box for you there stuff is fairly beefy