ScoobySport Back Box/Mid Section/Down Pipe
#2
Hi,
At the risk of being shot at by all the knowledgeable peeps out there...
On my P1 i've just had the SS down pipe fitted into the standard mid section & standard P1 BB.
It just flies. I've been told this set up only gives another 10 BHP but about 20 Lbft more torque.
The cars just had its 1st 1K service & I haven't yet taken it over 5K but the thing seems furiously quick, but then what do I know ?
Regards,
Simon
At the risk of being shot at by all the knowledgeable peeps out there...
On my P1 i've just had the SS down pipe fitted into the standard mid section & standard P1 BB.
It just flies. I've been told this set up only gives another 10 BHP but about 20 Lbft more torque.
The cars just had its 1st 1K service & I haven't yet taken it over 5K but the thing seems furiously quick, but then what do I know ?
Regards,
Simon
#3
I had a mix and match system and have changed to full ss.. what a differance! I would say stick to all the same sections to get the best torq, bhp, and flow that is the way it was tested when dyno'd.
TC (MOE)
TC (MOE)
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
55
05 August 2018 07:02 AM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
22 October 2015 06:12 AM