Does anyone know the outside diameter of the fuel line at the fuel filter please ?

 

I can tell you the fuel line pipes are 6-7mm internal bore so id say it would be 8mm Neil

 

Replaced mine with braided lines a few weeks ago, just gone and measured the pipes I took off. Barring the CC line, they're 14mm OD (8mm ID) hoses.

Got the OE ones I took off if you're stuck?

James

 

Me to mate,braided look the nuts don't they,have you got the anodized ends as well?

 

cheers for that fellas, P1 how many lines did you replase at the fuel filter side 3 ? anyone got any pics as well

 

On my set up i have 7 pieces but i have parallel fuel rails and fuellab fpr,what are you intending on doing neil?

 

for the moment just making the engine bay look more tidy fella, get ride of the horrible black rubber stuff, so to start with i thought i would do the fuell filter piping for a start

 

In that case there is 3 there one fuel feed,one fuel return and one for the carbon canister hose from the tank.

 

all the same size O.D ? what clams have you used as well ?

 

The fuel return is slightly bigger but the same size pipe will fit over them all mate

 

Yep and yep



Did the turbo coolant line in AN -10 as well while I was at it Fuel lines were all AN-6 hose from Pirtek and Earls (not the nylon stuff as it will never seal), with appropriate finishers. Give me half an hour and I'll post the link to where I got the finishers from if it helps...

James

 

thanks and very nice pic there P1 were did you get you lines and brackets from

 

Very nice fella,i'll post one of mine tomoz as its changed a fair bit since i posted my profile one's
Ive got the goodridge hoses on myn

 

Got braided hoses from Earls and Pirtek but the majority of the fittings were from Torques UK (http://stores.ebay.co.uk/id=81447352...STRK:MEFSX:SST). Very helpful people.

To fit over the rubber lined 8mm ID hose you'll need the 15mm (OD) hose finishers (the 12.5mm ones only fit the smaller ID nylon lined hose) available in red/blue/black/silver/chromed as far as I remember:

http://cgi.ebay.co.uk/6-AN6-15mm-Blu...item230a81b65d

I also used a few of these hose separators:

http://cgi.ebay.co.uk/6-AN6-AN06-9-1...item255ac7a799

 

thanks for all that fella