SwissTony

iTrader: (19)

I have an B&M short shift which was in my MY00 scoob. worked a treat.

Now trying to fit it into a 95 WRX which uses an earlier version of stablising bar and linkage. Does anyone know if you can do that (the earlier version is not the open ended bar) or would I have to purchase the version for the 95wrx/Legacy one ?

Paulo P

iTrader: (42)

At a guess I think we just need to change the stabiliser bar to the later one.

SwissTony

iTrader: (19)

Lets hope because I have found one and may be collecting it tomorrow

If not I shall be launching it through your front window

Paulo P

iTrader: (42)

It looks like an easy enough swap, where are you getting it from? Good luck with my window, you can't throw that far because you throw like a big girl

SwissTony

iTrader: (19)

Well if I stand on top of your beemer first, then onto your wheelie bin, I can just about reach

Greenford junction

Paulo P

iTrader: (42)

When you get it we can check it out, at least we know what we are looking at now We had no hope last weekend

You may as well bring your step ladder

SwissTony

iTrader: (19)

THe beemer is the step ladder


Might get it this weekend or tuesday all depends if I drive in tomorrow
Then can jack it up on the driveway and have a looky see

Paulo P

iTrader: (42)

Don't jack it under the rear