Mintex pads
07 August 2010, 08:15 PM
#1
Scooby Regular
Thread Starter
Join Date: Jun 2010
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
Mintex pads
Just changed all the discs and pads on 1993 wrx import ,pagid discs and mintex pads,the discs and rear pads fitted great.The front pads were slightly narrower than the red stuff pads that were on the car and had small nipples on back which had to be ground off because they fouled the caliper,is this normal or did they supply the wrong pads ?the box said
92-00 and the part no was one digit out from the rears.
92-00 and the part no was one digit out from the rears.
10 August 2010, 09:49 AM
#6
Scooby Regular
Thread Starter
Join Date: Jun 2010
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
They've got pagid stamped on the edge of em,and thats what the bloke at CRN products said they were when I emailed him.Just looked at the link you posted and under products it says they do " over 800 brake discs".
Last edited by slipwrx; 10 August 2010 at 09:52 AM.
23 December 2010, 01:41 PM
#7
Scooby Newbie
Join Date: Dec 2010
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
Post edited due to commercial content
Should you wish to trade with us on an official basis, please contact advertise@scoobynet.com
Should you wish to trade with us on an official basis, please contact advertise@scoobynet.com
Last edited by New_scooby_04; 23 December 2010 at 02:34 PM.
Trending Topics
23 December 2010, 02:42 PM
#9
Scooby Newbie
Join Date: Dec 2010
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
Pagid pads are licensed to TMD friction, the same company that makes Mintex pads.
EU regulations state that any aftermarket discs are manufactured to within a 15% tolerance of the original part. Pagid manufacture there product to within a 3-5% tolerance, aiming to work nearer the 3%. they achieve this by putting more carbon in the material which the discs are made up from. Many discs are manufactured to just scrape into the 15%.
Olly.
EU regulations state that any aftermarket discs are manufactured to within a 15% tolerance of the original part. Pagid manufacture there product to within a 3-5% tolerance, aiming to work nearer the 3%. they achieve this by putting more carbon in the material which the discs are made up from. Many discs are manufactured to just scrape into the 15%.
Olly.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM