2006 sti interior into classic
#3
Scooby Regular
Join Date: Nov 2008
Location: Tannadice
Posts: 362
Likes: 0
Received 0 Likes
on
0 Posts
I fitted 06 spec c seats in mine mate and it's a pretty easy job, only problems I ran into were the seat belt fasteners needed switched over and there was a 2 inch gap between the rear parcel shelf and top of seats that needed covered so you could not see the yellow foam.
They do sit a bit higher but driving position is fine, passenger seat does seem to sit higher than drivers though.
I would say go for it mate, transforms the inside of the car and I'm very pleased with mine.
They do sit a bit higher but driving position is fine, passenger seat does seem to sit higher than drivers though.
I would say go for it mate, transforms the inside of the car and I'm very pleased with mine.
#6
Scooby Regular
iTrader: (9)
Join Date: Mar 2004
Location: .
Posts: 20,035
Likes: 0
Received 0 Likes
on
0 Posts
Would really urge you to try the seats as I found them to be pretty poor. No idea about a Spec C, but standard 06 UK STI seats are too wide and do not hold you in like the Classic MY99/00 seats.
They will also raise your sitting position a little which annoys some people.
I put V7 STI seats in mine as mentioned above and they are great. Much narrower and hold you in properly. There is a problem with needing to sort out the rear seat where there is a gap at the top, but it's a relatively simple job to do.
They will also raise your sitting position a little which annoys some people.
I put V7 STI seats in mine as mentioned above and they are great. Much narrower and hold you in properly. There is a problem with needing to sort out the rear seat where there is a gap at the top, but it's a relatively simple job to do.
Thread
Thread Starter
Forum
Replies
Last Post
ATWRX
Full Cars Breaking For Spares
88
01 February 2016 07:28 PM