Notices
ScoobyNet General General Subaru Discussion
Sponsored by:
Sponsored by:

diagnostic check today

Thread Tools
 
Search this Thread
 
Old 09 September 2008, 02:10 PM
  #1  
bigdog666
Scooby Regular
Thread Starter
 
bigdog666's Avatar
 
Join Date: Feb 2008
Location: march, cambs
Posts: 144
Likes: 0
Received 0 Likes on 0 Posts
Thumbs up diagnostic check today

took my car to the scooby dealer today has i'v been getting a flashing/solid cel light on, and a squeal from the turbo at 4500, turns out the squeal is my boost guage, sure enough, i disconnected it and no squeal,so that was that sorted, but the history on the cel says it had misfired on all four cylinders at some point, i think it still does, if i get to about 4000 it stutters a bit then pulls fine, does it in every gear, could this be the chip or remap it had, has anyone else encountered this problem??
Old 09 September 2008, 03:14 PM
  #2  
El Cat
Scooby Regular
 
El Cat's Avatar
 
Join Date: Apr 2008
Location: Mount Hawke
Posts: 663
Likes: 0
Received 0 Likes on 0 Posts
Default

let us know as my brop has exactly the same problem
changed the coil pack and replaced the HT leads and no joy
think he is booiking her in to alan jeffs in plymouth over next few weeks
Old 09 September 2008, 03:41 PM
  #3  
stu turbo 98
Scooby Regular
iTrader: (6)
 
stu turbo 98's Avatar
 
Join Date: Jul 2008
Location: middlesex
Posts: 573
Likes: 0
Received 0 Likes on 0 Posts
Default

mine has had a similar sounding problem,i turned the boost up (no gauge so cant tell you what pressure)and whilst accelerating at certain revs the engine would seem to cut out for a split second then just kick in again,if i tried to press on it would keep doing it,but if i tried to accelerate a bit slower it wouldnt happen, i was told it was over boost,and advised to turn the boost down i did this and it stopped,at the time my cel was on due to a faulty tps ,so not sure if this will be the answer to your problem,but if you have boost control its an easy thing to check good luck.
Old 09 September 2008, 04:00 PM
  #4  
stu turbo 98
Scooby Regular
iTrader: (6)
 
stu turbo 98's Avatar
 
Join Date: Jul 2008
Location: middlesex
Posts: 573
Likes: 0
Received 0 Likes on 0 Posts
Default

turn the **** in the direction that makes the spring compress to turn the boost down,its clock wise on mine
Old 09 September 2008, 04:16 PM
  #5  
stu turbo 98
Scooby Regular
iTrader: (6)
 
stu turbo 98's Avatar
 
Join Date: Jul 2008
Location: middlesex
Posts: 573
Likes: 0
Received 0 Likes on 0 Posts
Default

sorry should have said ,you dont have to wind it right down, just do it gradually until the the problem stops,if it stops!and make sure that it is the bcv you are adjusting.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
KAS35RSTI
Subaru
27
04 November 2021 07:12 PM
Rbon91
ScoobyNet General
49
21 November 2018 03:23 PM
buckerz69
Wanted
2
03 October 2015 09:55 PM
thunder8
General Technical
0
01 October 2015 09:13 PM
WrxSti03
Drivetrain
0
30 September 2015 10:24 PM



Quick Reply: diagnostic check today



All times are GMT +1. The time now is 08:47 PM.