Hi guys and girls.

Has any1 got a spare resister needed to go in the lambda plug they could post me pls.

Got a second hand full system off e-bay (ferel racing T304) quite cheap.

Was just gonna fit it from the cat back but doesn't line up with the exhaust mounts so r gonna have to fit the full system.

Cheers

Ade

 

you sure they havent sent you a classic system?

 

no mate,

it came off a 2004 WRX

 

The resistor is for the exhaust gas temperature (EGT) sensor (unless there is another CEL fix using a resistor for the lambda sensor as well ?)

 

was just thinking with it not lining up with your existing brackets

 

i reckon the stainless downpipe should b alittle bit longer than the standard 1 so when fitting the full system it should move it all along abit to fit the brackets.

 

I did a search on here for cel problems and they all said it was for the lamdba sensor.

 

I have done a CEL fix on my WRX, it's a 2k2 ohm resistor bridged across the connector terminals.

It is for the EGT sensor at the top of the uppipe however, lambda sensor is down on one of the CATS ?

 

ok mate thanks

where did u get it from